![]() ![]() You’ll see the curves adjust the entire curve shifts so that the direction line remains tangent to the curve. Now, grab one of the direction line handles and pull. With the white arrow tool, select the point on the curve that you wish to tweak: Use the "white arrow tool" (known as the Direct Selection Tool in Illustrator and the Subselect Tool in Freehand) to tweak individual points and direction lines. The black arrow tool selects the entire path (so that you can move it around and resize it). The location at which you place the next point will affect the shape of the resulting curve, as you can see in the examples below: The resulting tangent line can be referred to as a "direction line" or a "handle." You can continue to hold and drag in different directions to see how the curve is affected. ![]() ![]() Then, click again - but this time, hold the mouse down and drag. With the same Pen Tool, click once to create a starting "corner" point. Bringing the cursor back to the original point and clicking will close the path to create a shape.Each new click creates a connected line segment with the previous point.Clicking with the pen tool creates corner points.If the cursor doesn’t change, it means that you aren’t quite on top of the original point, so you’ll end up just creating another point without closing the shape. When the cursor turns to a pen shape with a small circle, click on the point and the shape will be closed off. To "close" the path to actually make a shape, move the cursor to the original point. This creates a line that connects the two points.īy clicking again, you can start to create a shape: It sounds complicated, but once you get the hang of it, you’ll never look back!Ĭlick once on the document, then move the cursor and click again. Drawing the same shape with a pen tool involves a series of clicks and drags to set the anchor points and define curve directions. Unlike pencil-and-paper doodling (or comparatively, using a pencil- or brush-type tool in a typical drawing program), where your hand (or mouse) guides the drawn path, the pen tool creates shapes based on a series of points and their corresponding "direction lines" (Illustrator term) or "handles" (Freehand term).ĭrawing a complex shape with a pencil or brush tool usually involves clicking once to start the shape, then holding the mouse button down, and dragging the mouse to follow the lines of the shape. Becoming comfortable with the Pen Tool often takes a while for vector graphic newbies. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |